Canon Pixma MP530 - Manual (Page 18)

16 Chapter 1 Before Printing
„ Operation Panel Name and Functions
(1) [ON/OFF]
Turns the machine ON and OFF. Before turning ON the machine, make sure the
Document Cover is closed.
(2) [COPY]
Switches the machine to the Copy mode. Flashes when the machine is turned on.
(3) [FAX]
Switches the machine to the Fax mode.
(4) In Use/Memory Lamp
Flashes when the telephone line is in use. Lights when there are documents stored in the
machine's memory.
(5) [SCAN]
Switches the machine to the Scan mode. This button is used when the machine is
connected to a computer (Refer to the Scan Guide).
(6) Alarm Lamp
Lights or flashes orange, when an error occurs, or when paper or ink has run out.
(7) [Exposure]
Sets the copy intensity and fax intensity.
(8) [Enlarge/Reduce]
Sets the reduction or enlargement ratio for copying.
(9) LCD (Liquid Crystal Display)
Displays messages, menu selections, and the operation status.
(10) [Menu]
Displays menus to configure copy, fax, or machine settings.
(11) Numeric Buttons
Enters numerical values such as the number of copies, as well as fax/telephone numbers
and characters.
(12) [Redial/Pause]
Redials the last dialed number using numeric buttons. Also enters pauses between or
after numbers when dialing or registering numbers.
(13) [Coded Dial]
Press this button and a two-digit code to dial a pre-registered fax/telephone number.
Note
z The machine cannot receive faxes when the power is off.
z The power cannot be turned OFF while the machine is sending or receiving faxes, or
when there are unsent faxes stored in the machine’s memory.
(10)
(19)
(2) (3)
(4)
(9) (11) (1) (5) (7) (8)
(24) (22) (20) (18) (17) (14)
(6)
(15)
(12)
(13)
(16) (23) (21) (26) (25)