Canon Elura 100 - Manual (Page 114)

114
List of Messages
Memory Card Related Messages
Message Explanation
SET THE TIME ZONE,
DATE AND TIME You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time. 26
CHANGE THE BATTERY
PACK Battery pack is exhausted. Replace or charge the battery pack. 16
THE TAPE IS SET FOR
ERASURE PREVENTION Cassette is protected. Replace the cassette or change the
position of the protect switch. 118
REMOVE THE
CASSETTE Camcorder stopped operating to protect the tape. Unload and
reload the cassette. 19
CHECK THE INPUT DV cable is not connected, or the connected digital device is
turned off. 90
CONDENSATION HAS
BEEN DETECTED Condensation has been detected in the camcorder. 113
CONDENSATION HAS
BEEN DETECTED
REMOVE THE
CASSETTE Condensation has been detected in the camcorder. Unload the
cassette. 113
TAPE END Tape reached the end. Rewind the tape or replace the cassette. –
INCORRECT TAPE
SPECIFICATION You attempted to perform audio dubbing on a tape recorded in
HDV standard. –
INCORRECT TAPE
SPECIFICATION
PLAYBACK IS
RESTRICTED You attempted to play back a tape recorded in HDV standard. –
INPUT SIGNAL NOT
SUPPORTED You attempted to input video signal in HD standard through the
DV terminal. -
CHECK THE CASSETTE
[REC MODE] You attempted to perform audio dubbing on a tape recorded in a
mode other than the SP mode. 94
CHECK THE CASSETTE
[AUDIO MODE] You attempted to perform audio dubbing on a tape recorded in 16-
bit or 12-bit 4-channel sound. 94
CHECK THE CASSETTE
[BLANK] You attempted to perform audio dubbing on a tape with a blank
section. 94
HEADS DIRTY, USE
CLEANING CASSETTE Video heads are dirty. Clean the video heads. 120
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED You attempted to play back a copyright protected tape. 91
COPYRIGHT
PROTECTED DUBBING
RESTRICTED You attempted to dub a copyright protected tape. May also appear
when an anomalous signal is received during analog line-in
recording. 91
Message Explanation
NO CARD Memory card not is inserted into the camcorder. 20
NO IMAGES No images are recorded on the memory card. –
CARD ERROR A memory card error occurred. The camcorder cannot record or
play back the image.
The error may be temporary. If the message disappears after 4
seconds “
” flashes red, turn the camcorder off, remove the
card and reinsert the card. If “ ” changes to green, you can
continue recording/playback.
–