Canon ELURA 85 - Manual (Page 140)

140
COULD NOT PRINT X
IMAGES You attempted to use the print order settings to print X images that were
recorded with another camcorder, with a different compression or were
edited on a computer.
SET PRINT ORDER You attempted to print an image from the CARD PLAY menu
[
PRINT] without having set the print order.
PRINT ORDER
ERROR
You attempted to set more than 200 still images in the print order.
CANNOT TRIM You attempted to trim an image that was recorded with another
camcorder.
READJUST TRIMMING You changed the print style after you set the trimming settings.
PRINTER ERROR Cancel printing. Turn off the printer and turn it back on. Check the printer
status. If the error persists, consult your dealer or a Canon Service
Center listed in the Contact List provided with the printer or the printer
manual.
PRINT ERROR Cancel printing, disconnect the USB cable and turn off the printer. After a
while, turn the printer back on and reconnect the USB cable. Check the
printer status. If the error persists, consult your dealer or a Canon
Service Center listed in the Contact List provided with the printer or the
printer manual.
When you are printing using the
button, check the print settings.
HARDWARE ERROR Cancel printing. Turn off the printer and turn it back on. Check the printer
status. If the printer is equipped with a battery, it might be exhausted. In
such case, turn off the printer, replace the battery and turn it back on. If
the error persists, consult your dealer or a Canon Service Center listed in
the Contact List provided with the printer or the printer manual.
RECHARGE THE
PRINTER BATTERY The printer battery is depleted.
COMMUNICATION
ERROR The printer is experiencing a data transmission error. Cancel printing,
disconnect the USB cable and turn off the printer. After a while, turn the
printer back on and reconnect the USB cable. When you are printing
using the
button, check the print settings.
Or, you attempted to print from a memory card that contains a large
number of images. Reduce the number of images.
CHECK PRINT
SETTINGS The print setting cannot be used for printing with the button.
PRINTER IN USE The printer is in use. Check the printer status.
PRINTER WARMING UP Printer is warming up. If the message does not disappear after a few
seconds, check the printer status.
PAPER LEVER ERROR Paper lever error occurred. Adjust the paper selection lever to the proper
position.
PRINTER COVER OPEN Close the printer cover securely.
NO PRINTHEAD No print head is installed in the printer or print head is defect. Refer to the
instruction manual of your printer.
Message Explanation