Lithium button battery handling precautions, Cassette handling precautions, Protecting tapes from accidental erasure – Canon ELURA 85 User Manual

Page 144

Advertising
background image

144

Lithium Button Battery Handling Precautions

 Do not pick up the battery using tweezers or other metal tools as this will cause a short

circuit.

 Wipe the battery with a clean dry cloth to ensure proper contact.
 Keep the battery out of reach of children. If it is swallowed, seek medical assistance

immediately. The battery case may break and the battery fluids may damage stomach
and intestines.

 Do not disassemble, heat or immerse the battery in water to avoid the risk of explosion.

Cassette Handling Precautions

 Rewind tapes after use. If the tape becomes slack and damaged, it may cause picture

and sound distortion.

 Return cassettes in the case and store them upright.
 Do not leave the cassette in the camcorder after use.
 Do not use spliced tapes or nonstandard cassettes as they may damage the

camcorder.

 Do not use tapes that have been jammed as video heads may become dirty.
 Do not insert anything into the small holes of the cassette, or cover them with

cellophane tape.

 Handle cassettes with care. Do not drop or subject them to severe impact as this may

damage the cassettes.

 Rewind tapes from time to time if they are stored for a long time.
 With cassettes equipped with a memory function, metal plated terminals may become

dirty with use. Clean the terminals with a cotton swab after about 10 times of loading/
unloading. The memory function is not supported by the camcorder.

Protecting Tapes from Accidental Erasure

To protect your recordings from accidental
erasure, slide the tab on the cassette to SAVE
or ERASE OFF.

If you load a protected cassette in CAMERA
mode, the message “THE TAPE IS SET FOR
ERASURE PREVENTION” appears for
approx. 4 seconds and “

” starts flashing.

If you wish to record on that cassette, change the position of the tab.

WARNING!
• The battery used in this device may present a fire or chemical burn hazard if

mistreated. Do not recharge, disassemble, heat above 100 °C (212 °F) or incinerate
the battery.

CR1616:
• Replace the battery with a CR1616 made by Panasonic, Hitachi Maxell, Sony,

Toshiba, Varta or Renata. Use of other batteries may present a risk of fire or
explosion.

CR2025:
• Replace the battery with a CR2025 made by Panasonic, Hitachi Maxell, Sony, Sanyo,

or with Duracell2025. Use of other batteries may present a risk of fire or explosion.

SAVE

REC

SAVE

REC

Advertising
This manual is related to the following products: