Canon ELURA 85 - Manual (Page 61)

61
Advanced Fu
nc
tions
Recordi
ng
E
Audio Recording
Changing the Audio Mode
You can record sound in two audio modes—16-bit and 12-bit. The 12-bit mode records
sound on two channels (stereo 1), leaving 2 channels free (stereo 2) for adding new
sound later. Select the 16-bit mode for higher sound quality.
Open the menu and select [AUDIO SETUP]. Select [AUDIO MODE], set it
to [16bit] and close the menu.
“16bit” appears for approximately 4 seconds.
Using Headphones during Recording
The headphones terminal also serves as AV terminal. Headphones can only be used
when “
” is displayed on the screen. If not, change the setting following the procedure
below.
Open the menu and select [VCR SETUP]. Select [AV/PHONES ], set it to
[PHONES ] and close the menu.
Adjusting the Headphone Volume
Open the menu and select [AUDIO SETUP]. Select [ VOLUME], adjust
the volume with the SET dial and close the menu.
You can turn off the volume completely by turning the SET dial down until [OFF] appears.
Turn the SET dial up to increase the volume again.
CAMERA PLAY (VCR) CARD CAMERA CARD PLAY
MENU
( 38)
AUDIO SETUP AUDIO MODE•••12bit
CAMERA PLAY (VCR) CARD CAMERA CARD PLAY
MENU
( 38)
VCR SETUP AV/PHONES ••AV
CAMERA PLAY (VCR) CARD CAMERA CARD PLAY
MENU
( 38)
AUDIO SETUP VOLUME•••••