Canon REALiS X600 - Manual (Page 65)

User Command Specifications 9. Details of command LOGOPOS
1 LOGOPOS
LOGOPOS
LOGOPOS=<User image position setting parameters：ＩＤ>
User image position setting parameters
This sets the logo display position.
-1
A "busy" response is given while the zoom or focus lens is being driven.
-2
Menu
[Display settings] - [User screen settings] - [User image position]
[Display settings] - [User screen settings] - [User image position]
-3
-4
Setting
> LOGOPOS=UPPER_R This sets the logo display position to the upper right.
< i:OK
Reference
> GET LOGOPOS or ?LOGOPOS This retrieves the logo display position.
< g:LOGOPOS=LOWER_L
Acquisition of parameters which can be set
> RANGE LOGOPOS
< r:LOGOPOS=I,UPPER_L,UPPER_R,CENTER,LOWER_L,LOWER_R
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command States
OFF ON PM
Ч ○ Ч
Ч ○ Ч
* If a command cannot be supported, 'INVALID_MODE' or 'NOT_POWER_SUPPLIED' is returned as an error response.
* "i:BUSY" may be returned if the power status is being switched.
It can be executed when the projector is in both the remote mode and power-on status at the
same time.
"UPPER_L," "UPPER_R,"
"CENTER," "LOWER_L" or
"LOWER_R" can be set as the
user image position.
01.01** 01.01**
The current display position can be acquired using the applicable GET command.
SX60
X600
This command is the same as the menu functions in the table below.
SX50 SX6 SX60 X600
○
01.00**
This setting cannot be made unless the user screen is registered beforehand.
(Error "e:1002 NO_LOGO_CAPTURED" is returned.)
(Refer to the ZCONTDRV command and FCONTDRV command.)
Response
Example
"i:OK" is returned if the parameter was set properly.
For details, refer to the GET command.
Description
Model
SX50
SX6
Commands
CENTER
UPPER_L
Parameter
UPPER_R
Function
Parameter
ID Lower left
Meaning
Upper left
Lower right
Upper right
Center
Model Power Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50 ○ ○ ○ ○ ○ ○ – – ○ ○ ×
SX6 ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ×
SX60
Format
X600
Reference
The parameters which can be set at any given point in time can be obtained using the
RANGE command.
For details, refer to the RANGE command.
For all other responses, refer to "Error List."
LOWER_R
LOWER_L
User image position setting
Mode Control Setting
Commands
supported
○ ○ ○
01.01**
PAGE 57