Cabletron Systems HSIM-W6 User Manual
Page 177
Chapter 7: General Configuration Using Local Management
HSIM-W6 User’s Guide
163
To enable RIP , perform the following steps:
1.
From the IPX Configuration screen, highlight IPX RIP and then press ENTER.
The IPX RIP SETUP screen, shown in
2.
Use the arrow keys to highlight the Port field.
3.
Type in the number of the port that you wish to enable RIP routing and then press ENTER.
4.
Use the arrow keys to highlight the Port Level RIP field.
5.
Use the ENTER key to toggle the entry to ENABLED.
6.
Use the arrow keys to highlight the SAVE command at the bottom of the screen, and then press
ENTER. The message “SAVED OK” displays.
Figure 67
IPX RIP Setup Screen
System Level RIP:
Port Level RIP:
RETURN
SAVE
+PORT-
DISABLED
DISABLED
IPX Address: xxx.xxx.xxx.xxx
Port:
1
HSIM-W6 Local Management
Flash Image Version XX.XX.XX
IPX RIP CONFIGURATION