Wide area 1 and 2 configuration – Cabletron Systems HSIM-W6 User Manual
Page 80
Chapter 6: HSIM-W6 Configuration with QuickSET
66
HSIM-W6 User’s Guide
Wide Area 1 and 2 Configuration
Refer to the appropriate section listed below to configure your Wide Area 1 or 2 interface on the
HSIM-W6:
Wide Area T1 Configuration Window
Wide Area E1 Configuration Window
Wide Area DI Configuration Window
Wide Area Synchronous Configuration Window
Wide Area DDS Configuration Window
Wide Area HDSL Configuration Window
NOTES
When configuring the Wide Area 1 and 2 with
QuickSET, the WAN configuration
window that displays corresponds to the specific WPIM that is installed into the
HSIM-W6.
Configuration for the Wide Area 2 port is the same as the configuration for the Wide
Area 1 port.
Both Wide Area 1 and Wide Area 2 slots must be populated to proceed with Wide Area
port 2 configuration.