Dell PowerEdge 2450 - Manual (Page 20)

3-4 Dell PowerEdge 2450 Systems Installation and Troubleshooting Guide
#  ,    
Diskette write-protect feature
activated Move the write-protect tab on the
diskette.
# 
 Diskette missing from or improp-
erly inserted in diskette drive Reinsert or replace the diskette.
'  


 
'  



 
Embedded server management
memory may be temporarily
corrupted Shut down the system to clear
the memory, and then restart the
system. If the problem persists,
see Chapter 11, “Getting Help,”
for instructions on obtaining tech-
nical assistance.
/ 
-
 Faulty keyboard controller (defec-
tive system board) Replace the system board. See
Chapter 11, “Getting Help,” for
instructions on obtaining technical
assistance.
/

 Operating system corrupted or
not installed properly Reinstall the operating system.
0 
 

Incorrect configuration settings in
System Setup program, improp-
erly connected hard-disk drive,
faulty hard-disk drive controller
subsystem (defective system
board), or loose power cable Check the hard-disk drive configu-
ration settings in the System
Setup program. See Chapter 4,
“Using the System Setup Pro-
gram,” in the User's Guide for
instructions. Reinstall the
hard-disk drive. Check the inter-
face cable and power cable
connections to the backplane
board. See Chapter 10, “Installing
Hard-Disk Drives.”
$

 


 
  

'1"+  
Incorrect ISA_CLR jumper config-
uration, incorrect configuration
settings in System Setup pro-
gram, or faulty battery Remove the plug from the
ISA_CLR jumper. See
Appendix A, “Jumpers,
Switches, and Connectors” for
instructions. Check the System
Setup configuration settings.
See Chapter 4, “Using the Sys-
tem Setup Program,” in the
User's Guide for instructions.
Replace the battery. See
Chapter 8, “Installing System
Board Options.”








   


NOTE: For the full name of an abbreviation or acronym used in this table, see “Abbreviations and Acronyms."