Dell Vostro 1700 (Early 2009) - Manual (Page 120)

120
Troubleshooting
M EMORY DOUBLE WORD LOGIC FAILURE AT ADDRESS , READ VALUE EXPECTING
VALUE — A memory module may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them (see "Memory" on page 163).
M EMORY ODD / EVEN LOGIC FAILURE AT ADDRESS , READ VALUE EXPECTING
VALUE — A memory module may be faulty or improperly seated. Reinstall the
memory modules and, if necessary, replace them (see "Memory" on page 163).
M EMORY WRITE / READ FAILURE AT ADDRESS , READ VALUE EXPECTING VALUE — A
memory module may be faulty or improperly seated. Reinstall the memory
modules and, if necessary, replace them (see "Memory" on page 163).
N O BOOT DEVICE AVAILABLE — The computer cannot find the hard drive. If
the hard drive is your boot device, ensure that the drive is installed, properly
seated, and partitioned as a boot device.
N O BOOT SECTOR ON HARD DRIVE — The operating system may be corrupted.
Contact Dell (see "Contacting Dell" on page 195).
N O TIMER TICK INTERRUPT — A chip on the system board may be
malfunctioning. Run the System Set tests in the Dell Diagnostics (see "Dell
Diagnostics" on page 105).
N OT ENOUGH MEMORY OR RESOURCES . E XIT SOME PROGRAMS AND TRY AGAIN —
You have too many programs open. Close all windows and open the program
that you want to use.
O PERATING SYSTEM NOT FOUND — Reinstall the hard drive (see "Hard Drive"
on page 155). If the problem persists, contact Dell (see "Dell Diagnostics" on
page 105).
O PTIONAL R O M BAD CHECKSUM — The optional ROM has failed. Contact
Dell (see "Dell Diagnostics" on page 105).
A REQUIRED . D L L FILE WAS NOT FOUND — The program that you are trying to
open is missing an essential file. Remove and then reinstall the program.
Windows XP:
1 Click Start→ Control Panel→ Add or Remove Programs→ Programs and
Features.
2 Select the program you want to remove.
3 Click Uninstall.
4 See the program documentation for installation instructions.