Canon ELURA 50 - Manual (Page 155)

155
E
Additional Information
Miscellaneous
Cause and/or what to do about it
• The remote sensor mode is set to
OFF
B in the menu (
49).
• The remote sensor modes of the
wireless controller and the camcorder
itself are different (
49).
• The batteries are dead or not inserted.
• Check the screen displays ( 159).
• External interference may cause the
camcorder’s microprocessor to
malfunction temporarily. If random
letters appear in the display or if
normal operation is interrupted,
remove and then replace the power
source.
• Remove the cable and then reconnect
it or turn the power off and back on
again.
• This is not a malfunction.
Problem
? The wireless controller doesn’t
work.
? The power indicator is flashing.
? The camcorder malfunctions.
? The DV cable is connected
correctly, but there’s nothing in
the display.
? The camcorder becomes warm
during use.
• The memory card is not loaded
( 101).
• You are using an SD Memory Card and
it is set for erasure prevention. Change
the position of the protect switch.
• The memory card is full. Erase
images ( 120) or insert a new
memory card.
• You have reached the maximum file
number. Set the file numbering to
RESET through the menu (
104)
and insert a new memory card.
• You are using an unformatted
memory card. Format the card
(
139).
• The image is protected ( 119).
• You are using an SD Memory Card
and it is set for erasure prevention.
Change the position of the protect
switch.
? The PHOTO button doesn’t work.
? The image cannot be erased.