Canon ELURA 50 - Manual (Page 81)

81
E
Using the Full Range of Features
You can also choose to display camcorder data (shutter speed and exposure
settings) in the data code.
To change, open the menu and select DISP.SET UP. Then select DATA
CODE, set it to DATE/TIME, CAMERA DATA or CAM. & D/T and
close the menu.
DATA CODE•••DATE/TIME DISP.SET UP
( 39)
Setting the data code
Notes:
• The data code will read “– – –” in the following situations:
– During playback of a blank section of tape.
– If the tape was recorded before entering the date and time in the camcorder’s
memory.
– If the tape was recorded on a camcorder without a data code function.
– If noise or tape damage prevents the data code from being read.
• If a recording made on ELURA50 is played back on a different DV camcorder,
the data code may not be displayed correctly.
• The data code will appear in the display even if DISPLAYS ( 159) has been
set to OFF through the menu.
Possible data code combinations for tapes:
+ PLAY
(VCR)
TAPE
Date/Time Camera data
Date/Time &
Camera data
Time
Date & Time
Date
DATA CODE
(tape only)
D/TIME SEL.
F1.8
1/250
F1.8
1/250
JAN. 1,2003
12:00:00 PM
12:00 PM
JAN. 1,2003
F1.8
1/250
F1.8
1/250
JAN. 1,2003
F1.8
1/250
12:00:00 PM
F1.8
1/250
12:00 PM
JAN. 1,2003