Dell PowerEdge T100 - Manual (Page 54)

54
Installing System Components
8 Replace the front drive bezel. See "Replacing the Front Drive Bezel" on
page 49.
9 Close the system. See "Closing the System" on page 47.
10 Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
Installing a Diskette Drive
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 47.
3 Unpack the replacement diskette drive, and prepare it for installation.
4 Check the documentation for the drive to verify that it is configured for
your system.
5 Remove the front drive bezel. See "Removing the Front Drive Bezel" on
page 49.
6 Remove the 3.5-inch insert on the front drive bezel. See "Removing an
Insert on the Front Drive Bezel" on page 50.
7 Remove the four shoulder screws from the back of the insert. See
Figure 3-4; the 3.5-inch insert holds four screws.
8 Attach the four screws to the diskette drive as shown in Figure 3-7.
book.book Page 54 Wednesday, June 24, 2009 8:21 AM