Dell PowerEdge T100 - Manual (Page 96)

96
Installing System Components
3 Connect the switch cable to the INTRUSION SWITCH connector on the
system board.
4 Close the system. See "Closing the System" on page 47.
5 Reconnect the system to the electrical outlet, and turn on the system.
Bezel
Removing the Bezel
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 47.
3 Remove the heat sink and shroud assembly. See "Removing the Processor"
on page 81. Do not remove the processor, however.
4 Remove the large processor cooling fan. See "Removing the Cooling Fans"
on page 84.
5 Remove the two bezel release screws. See Figure 3-29.
6 Slide the bezel toward the top of the system, then lift it outward.
book.book Page 96 Wednesday, June 24, 2009 8:21 AM