Dell Inspiron One 2330 (Mid 2012) - Manual (Page 99)

System Board 99
26
System Board
WARNING: Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 9.
For additional safety best practices information, see the Regulatory Compliance
Homepage at dell.com/regulatory_compliance.
Removing the System Board
NOTE: Your computer’s Service Tag is stored in the system board. You must enter
the Service Tag in the BIOS after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of
the connectors so that you can reconnect them correctly after you replace
the system board.
Prerequisites
1 Remove the stand. See "Removing the Stand" on page 17.
2 Remove the back cover. See "Removing the Back Cover" on page 21.
3 Remove the VESA-mount bracket.
See "Removing the VESA-Mount Bracket" on page 41.
4 Remove the system-board shield.
See "Removing the System-Board Shield" on page 47
5 Remove the memory modules.
See "Removing the Memory Module(s)" on page 33.
6 Remove the power-supply fan bracket.
See "Removing the Power-Supply Fan Bracket" on page 71.
7 Remove the I/O cover. See "Removing the I/O Cover" on page 75.
8 Remove the I/O board shield.
See "Removing the I/O Board Shield" on page 79.
9 Remove the processor heat-sink.
See "Removing the Processor Heat-Sink" on page 59.
10 Remove the processor heat-sink fan.
See "Removing the Processor Heat-Sink Fan" on page 63.
OM_Book.book Page 99 Saturday, October 6, 2012 12:50 AM