Dell Studio 1558 (Early 2010) - Manual (Page 16)

8. Disconnect the camera cable, display cable, and power button cable from the connectors on the system board and release it from the routing guides.
9. Pull the antenna cables through the routing hole and release them from the routing channel.
10. Remove the two screws that secure the display assembly to the computer base.
11. Lift the display assembly off the computer base.
Replacing the Display Assembly
1. Follow the instructions in Before You Begin .
2. Align the display hinges with the holes in the computer base and then lower the display into place.
3. Replace the two screws that secure the display assembly to the computer base.
4. Slide the antenna cables through the routing hole to the base of the computer.
5. Secure the camera cable, display cable, and power button cable to their routing guides.
6. Connect the camera cable, display cable, and power button cable to their connectors on the system board.
7. Replace the keyboard (see Replacing the Keyboard ).
8. Replace the center control cover (see Replacing the Center Control Cover ).
9. Close the display and turn the computer over.
10. Replace the two screws that secure the display assembly to the computer base.
11. Replace the Mini-Card(s) and connect the antenna cables to it (see Replacing the Mini-Card ).
12. Replace the base cover (see Replacing the Base Cover ).
Display Bezel
Removing the Display Bezel
1 camera cable connector 2 display cable connector
3 power button cable connector 4 screws (2)
NOTE: Ensure that the display and camera cables are properly routed and secured beneath the routing guides.