Dell Studio 1558 (Early 2010) User Manual
Page 4
1.
Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.
2.
) and all attached devices.
3.
Disconnect all telephone or network cables from the computer.
4.
Disconnect your computer and all attached devices from their electrical outlets.
5.
Disconnect all attached devices from your computer.
6.
Press and eject any installed cards from the ExpressCard slot and the 8-in-1 Memory Card Reader.
7.
Turn the computer over.
8.
Slide the battery release latch until it clicks into place.
9.
Slide the battery out of the battery bay.
10.
Turn the computer top side up, open the display, and press the power button to ground the system board.
Back to Contents Page
CAUTION:
To disconnect a network cable, first unplug the cable from your computer, and then unplug it from the network device.
CAUTION:
To help prevent damage to the system board, you must remove the battery from the battery bay before you service the computer.
CAUTION:
To avoid damage to the computer, use only the battery designed for this particular Dell computer. Do not use batteries designed for
other Dell computers.
1
battery
2
battery release latch