Keyboard, Removing the keyboard, Replacing the keyboard – Dell Studio 1558 (Early 2010) User Manual
Page 26
Back to Contents Page
Keyboard
Dell Studio™ 1557/1558 Service Manual
Removing the Keyboard
1.
Follow the instructions in
Before You Begin
.
2.
Remove the center control cover (see
Removing the Center Control Cover
).
3.
Remove the two screws at the top of the keyboard.
4.
Lift the keyboard and hold it to access the keyboard cable connector.
5.
Disconnect the keyboard cable from the keyboard cable connector on the system board by rotating the keyboard cable connector latch towards the front
of the computer.
6.
Slide the keyboard cable out of the keyboard cable connector.
Replacing the Keyboard
1.
Follow the instructions in
Before You Begin
.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working
inside the computer.
CAUTION:
The key caps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
NOTE:
If you have the backlit keyboard (optional), you must remove the keyboard backlight cable from the connector on the system board.
1
screws (2)
2
keyboard tabs
3
keyboard cable connector
4
keyboard cable