Canon OPTURA10 - Manual (Page 144)

144
Additional
Information
E
List of Messages
Message Explanation
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the
time zone, date and time.
Battery pack is exhausted. Replace or charge the battery
pack.
Cassette is protected. Replace the cassette or change the
position of the protect switch.
Camcorder stopped operating to protect the tape. Unload
and reload the cassette.
DV cable is not connected, or the connected digital device is
turned off.
Condensation has been detected in the camcorder.
Tape reached the end. Rewind the tape or replace the
cassette.
You attempted to perform audio dubbing or AV insert on a
tape recorded in a mode other than the SP mode.
You attempted to perform audio dubbing on a tape
recorded in 16-bit or 12-bit 4-channel sound.
You attempted to perform audio dubbing or AV insert on a
tape with a blank section.
Video heads are dirty. Clean the video heads.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also
appear when an anomalous signal is received during analog
line-in recording, or during analog-digital conversion of a
copyright protected tape.
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE
BATTERY PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE
CASSETTE
CHECK THE DV INPUT
CONDENSATION HAS
BEEN DETECTED
TAPE END
CHECK THE CASSETTE
[REC MODE]
CHECK THE CASSETTE
[AUDIO MODE]
CHECK THE CASSETTE
[BLANK]
HEADS DIRTY, USE
CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS RESTRICTED
COPYRIGHT
PROTECTED DUBBING
RESTRICTED
25
16
23
22
89
148
22
52
97
95
148
92
92