Canon OPTURA10 - Manual (Page 99)

99
Editing
E
7. Press the STOP 3 button on the wireless controller
to stop dubbing.
Audio device: Stop playback.
Set the zero set memory at the end of the scene you wish to dub audio. The
camcorder will automatically stop audio dubbing at that point.
Playing Back the Added Sound
You can select to play back Stereo 1 (original sound), Stereo 2 (added sound), or adjust
the balance of both sounds.
1. Open the menu and select [AUDIO SET UP]. Select [12bit AUDIO OUT],
select a setting and close the menu.
• STEREO1: Plays back the original sound.
• STEREO2: Plays back the added sound.
• MIX/FIXED: Plays back stereo 1 and stereo 2 in the same level.
• MIX/VARI.: Plays back stereo 1 and stereo 2. The mix balance can be adjusted.
2. If you have selected [MIX/VARI.], adjust the mix level: Open the menu
and select [AUDIO SET UP]. Select [MIX BALANCE], adjust the balance
with the selector dial and close the menu.
Turn the selector dial down to increase the volume of Stereo 1 and up to increase the
volume of Stereo 2.
❍ The camcorder resets to [STEREO1] when you turn the camcorder off. However,
the mix balance is memorized by the camcorder.
❍ You can also press the 12bit AUDIO OUT button on the wireless controller to
select the audio output. However, the mix balance can only be adjusted in the
menu.
CARD CAMERA CARD CAMERA PLAY (VCR) CAMERA
REW
PAUSE
AV INSERT AV DV REMOTE SET
SLOW 2
PLAY
STOP
FF
ZERO SET
MEMORY
12bit
AUDIO OUT
AUDIO DUB.
MENU button
Selector dial
12bit AUDIO
OUT button
12bit AUDIO•••STEREO1 AUDIO SET UP
( 43)