Dell Metered PDU LCD - Manual (Page 48)

48 |
LCD Operation
Table 11. Settings (Continued)
Setting Option Default Setting Available Settings Settings
Submenu
Contact config. Contact 1 [Normally open], [Normally closed]
When set to normally open, the dry contact will
be active when the pins are shorted. When set
to normally closed, the dry contact will be
active when the pins are open.
Normally open
Contact 2 [Normally open], [Normally closed]
When set to normally open, the dry contact will
be active when the pins are shorted. When set
to normally closed, the dry contact will be
active when the pins are open.
Normally open
Password Password [Enabled] [Disabled]
If Enabled, the default password is USER. and
all settings are password-protected.
NOTE: If you enter an incorrect password, the
message “Incorrect Password” appears. Press
any button to return to the password screen and
retry the password.
Disabled
Factory setting Restore Factory Defaults [No], [Yes]
If No, no action.
If Yes, all configurable settings are restored to
factory default values.
NOTE: When you select [Yes] and press the
select button, a “Factory setting restored”
message displays. You are prompted to “Press
any key to continue.”
No
Clear event log Clear Event Log [No], [Yes]
If No, no action.
If Yes, all events in the log are cleared and the
Total Events value returns to 0.
No
* DELLM0001, DELLM001A, DELLM0004, DELLM004A, DELLM0006
** DELLM0002, DELLM0005, DELLM0007
*** DELLM0003
NOTE: For Delta models, L1 represents L1-L3 data, L2 represents L1-L2 data, and L3 represents L2-L3 data.