Dell Metered PDU LCD - Manual (Page 73)

73 Web Interface Operation |
Configuring DPI Attributes
This section explains:
S
Setting the Dell DPI system attributes
S
Resetting the Dell DPI configuration to default values
S Uploading or downloading configuration files
S
Configuring default file opening settings for Comma Separated Values (CSV) file formats
Setting Basic DPI Attributes
NOTE: Only the administrator can configure these settings.
To configure the Dell DPI:
1 From the System menu, click Configuration . The Configuration page displays.
2 Locate the System table.
3 Complete entries for attributes (see Table 20).
4 Click Save to apply the Dell DPI configuration settings in the System table.
5 This procedure is completed.
NOTE: These settings are in effect until the administrator enters new data and saves the changes. The present settings
can be viewed in this table at any time.
Table 20 describes the attributes in the System table.
Table 20. System
Attribute Description
System Name Dell system name. Limited to 31 characters. The default value is Dell PDU.
System Contact System manager defined in MIB-II. Limited to 31 characters.
System Location System installation locality defined in MIB-II. Limited to 31 characters.
Data Log Interval (Sec) Polling time (in seconds) of the history log.
Web Refresh Rate (Sec) Web refresh rate (in seconds) of the Summary, Input, and Environment pages in the
Power Management menu. Select from 4 to 10 seconds. The default value is 10
seconds.
Returning Configuration Settings to Default Values
NOTE: Only the administrator can configure these settings.
To return the configuration to default values:
1 From the System menu, click Configuration . The Configuration page displays.
2 Under Control, click the Reset to Default button.
The system is reset to the default configuration values.
3 This procedure is completed.