Physical description, Installation configurations – Dell Metered PDU LCD User Manual
Page 9
9
Introduction
|
Physical Description
Installation Configurations
The rPDUs can be mounted vertically in several installation configurations and orientations to accommodate
different site needs. Either one or two rPDUs can be installed in each rPDU tray in the back of a rack enclosure,
providing a total of up to four rPDUs (see Figure 2).
NOTE:
When installing two rPDUs in a side-by-side configuration, you are not restricted to installing the same model.
Figure 2. One or Two rPDUs Installed in the rPDU Tray
The standard mounting orientation for the rPDU is 180°. This is a snap-in, tooless installation. Two
factory-installed mounting pegs are inserted in mounting keyholes on the wall of the rPDU tray.
NOTE:
The 180° orientation means that the mounting surface (the back of the rPDU) is 180° in relation to the front
receptacles.
The rPDU can also be mounted in a 90°
orientation. For this configuration, two deep mounting pegs (provided)
are user-installed before mounting the rPDU in the rPDU tray (see Figure 3).
NOTE:
The 90° orientation means that the mounting surface (the side of the rPDU) is 90° in relation to the front
receptacles.