Dell Dimension 9200 - Manual (Page 104)

104
Removing and Installing Parts
General Installation Guidelines
Connect the hard drives to the connectors labeled "SATA0" and "SATA1", starting with SATA0. Connect
CD/DVD drives to the connectors labeled "SATA4" or "SATA5", starting with SATA4.
Serial ATA hard drives and CD/DVD drives are connected to the connectors labeled "SATA0" to "SATA5"
on the system board.
When connecting and disconnecting a serial ATA cable, hold the cable by the connector at each end.
Hard Drive
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
If you are replacing a hard drive that contains data, back up your files before you begin this procedure
DIM_book.book Page 104 Monday, October 15, 2007 11:04 AM