Dell Dimension 9200 - Manual (Page 106)

106
Removing and Installing Parts
5 Replace the computer cover (see "Replacing the Computer Cover" on page 121).
6 If removing this drive changes the drive configuration, then be sure to reflect these changes in the
BIOS. When you restart your computer, enter system setup (see "System Setup" on page 127). Then,
go to the "Drives" section of the BIOS and under
SATA 0 through 5 , set the SATA ports to the
correct configuration.
Installing a Hard Drive
1 Follow the procedures in "Before You Begin" on page 77.
2 Remove the computer cover (see "Removing the Computer Cover" on page 78).
3 Unpack the replacement hard drive, and prepare it for installation.
4 Check the documentation for the drive to verify that the drive is configured for your computer.
5 If your replacement hard drive does not have the hard drive bracket attached, remove the bracket from
the old hard drive by unsnapping it from the drive.
6 Snap the hard drive bracket onto the replacement hard drive.
7 Install the hard drive into the computer by sliding the drive into place until you feel it click into place.
8 Connect the power and hard drive cables to the hard drive.
1 hard drive 2 hard drive bracket
1
2
DIM_book.book Page 106 Monday, October 15, 2007 11:04 AM