Dell Dimension 9200 - Manual (Page 109)

Removing and Installing Parts
109
9 Replace the computer cover ("Replacing the Computer Cover" on page 121).
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
10 Connect your computer and devices to electrical outlets, and then turn them on.
11 When you restart your computer, enter system setup (see "System Setup" on page 127). Then, go to
the "Drives" section of the BIOS and under SATA 0 through 5 , set the SATA port to "ON" for the
hard drive you just installed. This enables the drive.
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
Floppy Drive
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTE:
If you are adding a floppy drive, see "Installing a Floppy Drive" on page 111.
Removing a Floppy Drive
1 Follow the procedures in "Before You Begin" on page 77.
2 Remove the computer cover (see "Removing the Computer Cover" on page 78).
3 Remove the drive pane "Removing the Drive Panel" on page 100).
4 Disconnect the power and floppy drive cables from the back of the floppy drive.
5 Unhook floppy drive cable from the clips on the processor shroud. Disconnect the other end of the
floppy drive cable from the system board. Remove the floppy drive cable from the computer.
DIM_book.book Page 109 Monday, October 15, 2007 11:04 AM