Dell Dimension 9200 - Manual (Page 134)

134
Appendix
Clearing Forgotten Passwords
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
1 Follow the procedures in "Before Working Inside Your Computer" on page 78.
2 Locate the 2-pin password jumper (CLRPSWD) on the system board (see "System Board
Components" on page 81), and remove the jumper to clear the password.
NOTE:
When you receive your computer, the jumper plug is attached to pins 1 and 2.
3 Replace the computer cover (see "Replacing the Computer Cover" on page 121).
4 Connect your computer and monitor to electrical outlets, and then turn them on.
5 After the Microsoft
®
Windows
®
desktop appears on your computer, shut down the computer (see
"Turning Off Your Computer" on page 77).
6 Turn off the monitor and disconnect it from the electrical outlet.
7 Disconnect the computer power cable from the electrical outlet, then press the power button to
ground the system board.
8 Remove the computer cover (see "Removing the Computer Cover" on page 78).
9 Locate the 2-pin password jumper (CLRPSWD) on the system board (see "System Board
Components" on page 81) and attach the jumper to pins 1 and 2 to reenable the password feature.
10 Replace the computer cover (see "Replacing the Computer Cover" on page 121).
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug it into the
computer.
11 Connect your computer and devices to electrical outlets, and then turn them on.
DIM_book.book Page 134 Monday, October 15, 2007 11:04 AM