Dell Dimension 9200 - Manual (Page 57)

Solving Problems
57
Memory Problems
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
Mouse Problems
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
I F YOU RECEIVE AN INSUFFICIENT MEMORY MESSAGE —
• Save and close any open files and exit any open programs you are not using.
• See the software documentation for minimum memory requirements. If necessary, install additional
memory (see "Installing Memory" on page 83).
• Reseat the memory modules (see "Memory" on page 82) to ensure that your computer is successfully
communicating with the memory.
• Run the Dell Diagnostics (see "Dell Diagnostics" on page 68).
I F YOU EXPERIENCE OTHER MEMORY PROBLEMS —
• Reseat the memory modules (see "Memory" on page 82) to ensure that your computer is successfully
communicating with the memory.
• Ensure that you are following the memory installation guidelines (see "Installing Memory" on page 83).
• Your computer supports DDR2 memory. For more information about the type of memory supported by
your computer, see "Memory" on page 123.
• Run the Dell Diagnostics (see "Dell Diagnostics" on page 68).
C LEAN THE MOUSE — For instructions on cleaning the mouse, see "Cleaning the Mouse" on page 35.
C HECK THE MOUSE CABLE —
1 Remove any mouse extension cables, and connect the mouse directly to the computer.
2 Verify that the mouse cable is connected as shown on the setup diagram for your computer.
DIM_book.book Page 57 Monday, October 15, 2007 11:04 AM