Dell PowerVault DR4100 - Manual (Page 11)

Drive-Status
Indicator Pattern
(RAID Only) Condition
Steady green Drive online
Blinks green three
seconds, amber three
seconds, and off six
seconds Rebuild aborted
Back-Panel Features And Indicators
The following topic describes the back-panel features and indicators of the Dell DR4100 system.
Figure 3. Back-Panel Features And Indicators
Item Indicator, Button, or
Connector
Icon Description
1 System identification button The identification buttons on the front and back panels
can be used to locate a particular system within a rack.
• When one of these buttons is pressed, the system
status indicator on the back flashes until one of
the buttons is pressed again.
• Press to toggle the system ID on and off.
• If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
• To reset iDRAC (if not disabled in F2 iDRAC setup)
press and hold the button for more than 15
seconds.
2 System identification
connector Connects the optional system status indicator assembly
through the optional cable management arm.
3 iDRAC7 Enterprise port Dedicated management port.
NOTE: The port is available for use only if the iDRAC7
Enterprise license is installed on your system.
4 PCIe expansion card slots
low-profile (3) Allows you to connect up to three PCI Express expansion
cards.
5 Serial connector Allows you to connect a serial device to the system.
6 Video connector Allows you to connect a VGA display to the system.
11