Dell Acceleration Appliances for Databases - Manual (Page 22)

• Assign initiators to the
BLUE2
group.
• Create a LUN for the
BLUE2
initiators to access the Test2 volume.
Here is the script that does the tasks:
profile:create reliable_performance
volume:create --cluster Test2 595 pool_md3
inigroup:create BLUE2
initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:ca IONb2_1
initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:cb IONb2_2
initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:c8 IONb2_3
initiator:create --assign BLUE2 21:00:00:24:ff:69:d4:c9 IONb2_4
initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:ca --id IONb2_1
initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:cb --id IONb2_2
initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:c8 --id IONb2_3
initiator:update --assign BLUE2 21:00:00:24:ff:69:d4:c9 --id IONb2_4
lun:create --all-targets --blocksize 512 Test2 BLUE2
SOFTWARE UPDATE
For more information on the software update process, see Software Commands in the
Command-Line Reference section.
If your current software version is earlier than 2.2.0, do not use the steps in either this guide
or the ION Accelerator GUI Guide to update the software. Instead, refer to the current ION
Accelerator Release Notes for the two-part update procedure.
To do a non-disruptive software update, follow the steps below (refer to the instructions for each
command for more details).
1. Obtain the ION Accelerator build file (
.iop
) from Fusion-io Customer Support.
2. Log in to each node that is to be updated, using the physical IP address of the node.
3. Copy the
.iop
file onto the local ION Accelerator node. To do this, run the following CLI
command (assuming an update to version 2.4.0):
soft:upload
This will place the
.iop
file under
/home/admin
.
4. To perform the update for the first node, run these commands:
soft:apply
5. Wait until the update is complete.
22