Dell DX6012S - Manual (Page 60)

64
Using the System Setup Program and UEFI Boot Manager
NOTE:
Certain platform configurations may not support the full set of features
provided by the controller.
The following features of the Lifecycle Controller are supported on systems
with Baseboard Management Controller (BMC):
• Installing an operating system
• Running diagnostics to validate the memory, I/O devices, processors,
physical disks, and other peripherals
When an optional iDRAC6 Express card is installed, the controller provides
the following additional features:
• Downloading and applying firmware updates
• Configuring hardware and firmware
For more information about setting up the controller, configuring hardware
and firmware, and deploying the operating system, see the
Lifecycle Controller
User Guide on the Dell Support website at support.dell.com/manuals.
Baseboard Management Controller Configuration
NOTE:
If an iDRAC6 Express card is installed on the system, the Baseboard
Management Controller (BMC) utility is replaced by the iDRAC6 utility.
The BMC enables configuring, monitoring, and recovery of systems remotely.
BMC provides the following features:
• Uses the system’s integrated NIC
• Enables fault logging and SNMP alerting
• Provides access to system event log and sensor status
• Allows control of system functions including power on and off
• Functions independently of the system’s power state or the system’s
operating system
• Provides text console redirection for system setup, text-based utilities,
and operating system consoles
NOTE:
To remotely access the BMC through the integrated NIC, you must connect
the network connection to integrated NIC1.
For additional information on using BMC, see the documentation for the
BMC and systems management applications.
book.book Page 64 Friday, February 26, 2010 11:22 AM