Dell Inspiron 3500 - Manual (Page 37)

Removing and Replacing Parts 4-1
& + $ 3 7 ( 5  
5HPRYLQJDQG5HSODFLQJ3DUWV
This chapter provides procedures for removing and replacing parts and assem-
blies. Unless otherwise noted, each of the procedures in this chapter makes
the following assumptions:
‡
The computer and any attached peripherals are turned off and the peripher-
als are disconnected from the computer’s I/O panel.
‡
A part can be replaced or installed by performing the removal procedure in
reverse order.
When performing the procedures in this chapter that require the computer to
be open, use a book or something similar to support the display assembly. The
angle of the display assembly with respect to the base assembly should not
exceed 140 degrees.
Locations or directions relative to the computer are shown in Figure 4-1 unless
otherwise specified.
)LJXUH  &RPSXWHU 2ULHQWDWLRQ
5HFRPPHQGHG7RROV
Most of the procedures require the use of one or more of the following tools:
‡
Small flat-blade screwdriver
‡
# 1 Phillips-head screwdriver
‡
Antistatic grounding strap
‡
Dental pick or similar pointed instrument
right side left side
back of computer
front of computer