Dell PowerVault DL2100 - Manual (Page 102)

102
Installing System Components
Replacing the Fan Bracket
1 Align the fan bracket down onto the bracket base so that the mounting
pins fit correctly into the bracket base. See Figure 3-15.
2 Insert the bracket and engage the release levers to lock it in place.
3 If removed, replace the fans in the fan bracket. See "Replacing a Cooling
Fan."
4 Close the system. See "Closing the System."
Optical Drive
An optional slimline DVD-ROM or DVD+RW optical drive slides into the front
panel and connects to the SATA controller on the system board. The optical
drive is on the right or left side of the system, depending on your chassis.
NOTE:
DVD devices are data only.
Removing the Optical Drive
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2 Open the system. See "Opening the System."
3 Disconnect the optical drive cable from the back of the optical drive.
4 To remove the optical drive, press down on the blue release tab at the back
of the optical drive and push the drive out of the system. See Figure 3-16.
Installing the Optical Drive
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and