Replacing expansion-card riser 1 – Dell PowerVault DL2100 User Manual
Page 117
Installing System Components
117
2 Open the system. See Opening the System.
3 Disconnect all cables connected to the expansion card.
4 Remove all expansion cards from the expansion-card riser. See Removing
5 Press the tab at the bottom of the riser to release the board from the card
slot and lift expansion-card riser 1 off of the mounting pins and out of the
system. See Figure 3-23.
Replacing Expansion-Card Riser 1
NOTE:
The system will not start with a riser board removed.
1 Aligning the pin collar over the mounting pin on the system board, lower
expansion-card riser 1 until the board connector is firmly seated into the
system board socket. See Figure 3-23.
2 Reinstall any expansion cards. See "Installing an Expansion Card."
3 Reconnect all expansion-card cables.
4 Close the system. See "Closing the System."
5 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.