Removing an idrac6 enterprise card, Figure 3-11, Down until it is fully seated. see figure 3-11 – Dell PowerVault DL2100 User Manual
Page 94
94
Installing System Components
Figure 3-11.
Removing and Installing the iDRAC6 Enterprise Card
Removing an iDRAC6 Enterprise Card
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System."
3 If installed, remove all expansion cards from expansion-card riser 1. See
4 Remove the VFlash media card (if installed) from the iDRAC6 Enterprise
card. See "VFlash Media (Optional)."
5 If present, disconnect the Ethernet cable from the iDRAC6 Enterprise
card.
1
iDRAC6 Enterprise card
2
VFlash media slot
3
VFlash SD card
4
retention standoff posts (2)
5
iDRAC6 Enterprise card connector
2
5
1
4
3