Dell DX6004S User Manual

Page 39

Advertising
background image

About Your System

39

Invalid PCIe card
found in the
Internal_Storage
slot!

The system halted because

an invalid PCIe expansion

card is installed in the

dedicated storage controller

slot.

Remove the PCIe expansion

card and install the

integrated storage controller

in the dedicated slot. See

"Getting Help" on page 161.

Keyboard fuse has
failed.

Overcurrent detected at the

keyboard connector.

See "Getting Help" on

page 161.

Local keyboard
may not work
because all user
accessible USB
ports are
disabled.
If operating
locally, power
cycle the system
and enter system
setup program to
change settings.

The USB ports are disabled

in the system BIOS.

Power down and restart the

system from the power

button, and then enter the

System Setup program to

enable the USB port(s).

See "Entering the System

Setup Program" on page 52.

Manufacturing
mode detected.

System is in manufacturing

mode.

Reboot to take the system

out of manufacturing mode.

Maximum rank
count exceeded.
The following
DIMM has been
disabled: x.

Invalid memory

configuration. The system

will run but with the

specified memory module

disabled.

Ensure that the memory

modules are installed in a

valid configuration. See

"General Memory Module

Installation Guidelines" on

page 98.

Memory
Initialization
Warning: Memory
size may be
reduced.

Invalid memory

configuration. The system

will run but with less memory

than is physically available.

Ensure that the memory

modules are installed in a

valid configuration.

See "General Memory

Module Installation

Guidelines" on page 98.

Table 1-2. System Messages

(continued)

Message

Causes

Corrective Actions

book.book.book Page 39 Tuesday, September 7, 2010 8:45 PM

Advertising