Dell B3465dnf Mono Laser Multifunction Printer - Manual (Page 160)

Use To
Timeouts
Standby Mode
Disabled
1–240
Set the amount of time before the printer enters a lower power
state.
Note: 15 minutes is the factory default setting.
Timeouts
Sleep Mode
Disabled
1–120
Set the amount of time the printer waits after a job is printed before
it goes into a reduced power state.
Notes:
• 20 minutes is the factory default setting.
• Lower settings conserve more energy, but may require
longer warm
‑up times.
• Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in the
room.
• Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm
‑up time.
• Disabled appears only if Energy Conserve is set to Off.
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Print a job while the display is off.
Note: Display on when printing is the factory default setting.
Timeouts
Hibernate Timeout
Disabled
20 minutes
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Set the amount of time before the printer enters Hibernate mode.
Note: 3 days is the factory default setting.
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Set the printer to Hibernate mode even if there is an active Ethernet
or phone connection.
Note: Hibernate is the factory default setting.
Timeouts
Screen Timeout
15–300
Set the amount of time the printer waits before returning the
display to Ready state.
Note: 30 is the factory default setting.
Timeouts
Prolong Screen Timeout
On
Off
Continue a specified job without returning to the home screen
when the screen timeout timer expires.
Note: Off is the factory default setting.
Understanding the printer menus 160