Dell B3465dnf Mono Laser Multifunction Printer - Manual (Page 249)

If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install
a genuine Dell supply or part.
Note: For the list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit
www.dell.com/support/printers .
Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message and continue printing.
• Delete fonts, macros, and other data stored in the flash memory.
• Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.
Paper changes needed
Try one or more of the following:
• From the printer control panel, touch Prompt for each page to continue printing.
• Touch Use current supplies to continue printing using the paper loaded in the tray.
• Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message.
• Enable the parallel port. From the printer control panel, navigate to:
Network/Ports > Parallel [x] > Parallel Buffer > Auto
Note: The printer discards any data received through the parallel port.
Printer had to restart. Last job may be incomplete.
From the printer control panel, touch Continue to clear the message and continue printing.
For more information, visit www.dell.com/support/printers or contact technical support.
Remove defective disk [61]
Remove and replace the defective printer hard disk.
Remove paper from standard output bin
Remove the paper stack from the standard bin.
Troubleshooting 249