Dell B3465dnf Mono Laser Multifunction Printer - Manual (Page 67)

• Do not use preprinted card stock manufactured with chemicals that may contaminate the printer. Preprinting
introduces semi
‑liquid and volatile components into the printer.
• Use grain short card stock when possible.
Paper guidelines
Selecting the correct paper or specialty media reduces printing problems. For the best print quality, try a sample of the
paper or specialty media before buying large quantities.
Paper characteristics
The following paper characteristics affect print quality and reliability. Consider these characteristics when evaluating
new paper stock.
Weight
The standard printer trays can automatically feed paper weights up to 90
‑g/m 2 (24
‑lb) bond grain long paper. The
optional trays can automatically feed paper weights up to 120
‑g/m
2 (32
‑lb) bond grain long paper. The multipurpose
feeder can automatically feed paper weights up to 163
‑g/m 2 (43
‑lb) bond grain long paper. Paper lighter than
60 g/m 2 (16 lb) might not be stiff enough to feed properly, causing jams. For best performance, use 75
‑g/m 2 (20
‑lb)
bond grain long paper. For paper smaller than 182 x 257 mm (7.2 x 10.1 inches), it is recommended to use 90 g/m 2
(24 lb) or heavier paper.
Note: Two
‑sided printing is supported only for 60–90‑g/m 2 (16–24
‑lb) bond paper.
Curl
Curl is the tendency for paper to curl at its edges. Excessive curl can cause paper feeding problems. Curl can occur after
the paper passes through the printer, where it is exposed to high temperatures. Storing paper unwrapped in hot, humid,
cold, or dry conditions, even in the trays, can contribute to paper curling prior to printing and can cause feeding
problems.
Smoothness
Paper smoothness directly affects print quality. If paper is too rough, toner cannot fuse to it properly. If paper is too
smooth, it can cause paper feeding or print quality issues. Always use paper between 100 and 300 Sheffield points;
smoothness between 150–250 Sheffield points produces the best print quality.
Moisture content
The amount of moisture in paper affects both print quality and the ability of the printer to feed the paper correctly.
Leave paper in its original wrapper until it is time to use it. This limits the exposure of paper to moisture changes that
can degrade its performance.
Condition paper before printing by storing it in its original wrapper in the same environment as the printer for 24–48
hours before printing. Extend the time to several days if the storage or transportation environment is very different
from the printer environment. Thick paper may also require a longer conditioning period.
Grain direction
Grain refers to the alignment of the paper fibers in a sheet of paper. Grain is either grain long, running the length of
the paper, or grain short, running the width of the paper.
Paper and specialty media guide 67