Dell PowerVault MD3000i - Manual (Page 13)

About Your System
13
Each MD3000i RAID controller module also contains a SAS Out port
connector. This port allows you the option to connect the RAID enclosure to
an expansion enclosure.
Refer to the PowerVault MD3000i Installation Guide for details and illustrated
examples of how to configure your storage array.
Hardware Features
The remainder of this section describes the hardware features available on the
RAID enclosure, including:
• Indicators on the enclosure bezel
• Front-panel and back-panel indicators and features
• Redundant power supply and cooling fan modules
Indicators on the Enclosure Bezel
An optional locking bezel can be installed on the front of the enclosure to
limit access. Figure 1-1 illustrates the indicators and components on the bezel.
Table 1-1 lists conditions indicated by the lights on the bezel. For information
on installing and removing the bezel, see "Removing and Replacing the Front
Bezel" on page 55.
Figure 1-1. LEDs on the Front Bezel
1
2
3