Dell PowerVault MD3000i - Manual (Page 56)

56
Installing Enclosure Components
Figure 3-1. Installing and Removing the Front Bezel
4 To replace the bezel, insert the interlocking notch into the U-shaped
handle on the side of the front enclosure panel.
5 Snap the left side of the bezel into place in the U-shaped handle on the
left side of the enclosure.
6 To lock the bezel, insert the key and turn to the right.
Removing and Installing Physical Disks
Your enclosure supports up to 15 SAS 3.0-Gbps physical disks, each one
contained in its individual disk carrier. Physical disks are connected directly to
the enclosure midplane and are hot-pluggable, allowing you to remove and
insert disks without shutting down your enclosure.
This section describes how to remove and install physical disks in your storage
array.
NOTICE:
Extra care must be taken when handling and storing the physical disks.
The carriers provide some protection, but the disks and carrier connectors can be
damaged by rough handling. When removing the physical disks from the enclosure,
place them on a padded surface. Never drop the disks.
1 bezel lock 2 release tab/interlocking notch 3 U-shaped handle
2
1
3