Clearing cmos settings – Dell Alienware Area 51 (Late 2009) User Manual
Page 102
0102
0102
/
CHAPTER 19: SYSTEM SETUP
Clearing CMOS Settings
NOTE: This procedure does not clear or reset system and setup
passwords.
Follow the instructions in “Before You Begin” on page
1.
Remove the left side-panel (see “Removing the Left Side-Panel” on page
2.
Remove the PCI shroud (see “Removing the PCI Shroud“ on page
3.
22).
Locate the 3-pin CMOS reset jumper on the system board (see “System
4.
Board Components” on page 11).
Remove the jumper plug from the CMOS reset jumper pins 1 and 2.
5.
Place the jumper plug on the CMOS reset jumper pins 2 and 3 and wait for
6.
approximately five seconds.
Remove the jumper plug and replace it on the CMOS reset jumper pins
7.
1 and 2.
Replace the PCI shroud (see “Replacing the PCI Shroud” on page
8.
22).
Replace the left side-panel (see “Replacing the Left Side-Panel” on page
9.
Connect your computer and devices to electrical outlets, and then turn
10.
them on.