Removing the chassis-intrusion switch, Replacing the chassis-intrusion switch – Dell Alienware Area 51 (Late 2009) User Manual
Page 19
019
019
/
CHAPTER 3: CHASSIS
1
1
chassis-intrusion switch
Removing the Chassis-Intrusion Switch
Follow the instructions in “Before You Begin” on page
1.
Remove the left side-panel (see “Removing the Left Side-Panel” on page
2.
Disconnect the chassis-intrusion switch cable from the master I/O board
3.
connector.
Slide the chassis-intrusion switch towards the top of the computer and then
4.
pull it away.
Replacing the Chassis-Intrusion Switch
Follow the instructions in “Before You Begin” on page
1.
Route the chassis-intrusion switch cable through the chassis and connect it
2.
to the master I/O board connector.
Replace the chassis-intrusion switch in the chassis.
3.
Slide the chassis-intrusion switch towards the bottom of the computer until
4.
the chassis-intrusion switch snaps into place.
Replace the left side-panel (see “Replacing the Left Side-Panel” on page
5.
Connect your computer and devices to electrical outlets, and then turn
6.
them on.