Dell PowerEdge 6850 - Manual (Page 64)

5. Remove the filler bracket on the slot.
6. Insert the Fibre Channel module card firmly into the Fibre Channel module card connector until the card is fully seated.
7. Close the Fibre Channel module card retainer. See Figure 6 -9 .
8. Connect any internal or external cable(s) to the card.
9. Close the system. See " Closing the System " in "Troubleshooting Your System."
Removing a Fibre Channel Module Card
1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See " Opening the System " in "Troubleshooting Your System."
3. Remove memory risers cards C and D. See " Removing and Installing a Non–Hot-Pluggable Memory Riser Card ."
4. Disconnect any internal or external cable(s) that are connected to the card.
5. Open the Fibre Channel module card retainer adjacent to the slot. See Figure 6 -9 .
6. Grasp the Fibre Channel module card and carefully remove it from the system-board connector.
7. If you are permanently removing the card, replace the metal filler bracket over the empty card-slot opening.
NOTE: Keep this bracket if you need to remove the Fibre Channel module card. Filler brackets must be installed over empty card slots to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
NOTE: Ensure that the Fibre Channel module card bracket is also inserted into the securing slot at the bottom of the bracket slot.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as
authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: Filler brackets must be installed over empty card slots to maintain FCC certification of the system. The brackets also keep dust and dirt out
of the system and aid in proper cooling and airflow inside the system.