Dell POWEREDGE M1000E - Manual (Page 235)

Web Tools Administrator’s Guide 207
53-1002756-01
Allow / Prohibit Matrix configuration
16
The Port Connectivity table (shown in Figure 45 on page 209) displays the Port number (in
physical-location format), Port Name (port address name), Block attribute, Prohibit attribute, and
Area Id (port address, displayed in hexadecimal) in fixed columns. The right side is a port matrix,
that lists all ports by Area ID and identifies prohibited ports. Those columns are scrollable and
swappable.
Viewing Allow / Prohibit Matrix configurations
To display a list of Allow / Prohibit Matrix configurations, perform the following steps.
1. Select a FICON-enabled switch from the Fabric Tree.
2. Select Configure > Switch Admin.
3. Click Show Advanced Mode to see all the available tabs and options.
4. Select the FICON CUP tab.
The FICON CUP page displays the FICON Management Server page in front. All attributes on
this page are read-only until FMS mode is enabled.
5. Click the Allow / Prohibit Matrix subtab.
Modifying Allow / Prohibit Matrix configurations
In the Allow / Prohibit Matrix Configuration dialog box, swapped ports are indicated with the
“(Swapped)” label (
Figure 44 ).
FIGURE 44 Edit Allow / Prohibit Matrix dialog box swapped label
To create a new Allow / Prohibit Matrix configuration or to edit an existing configuration, perform
the following steps.
1. Display the Allow / Prohibit Matrix configuration list.
2. You can either create a new configuration or edit an existing configuration:
• To create a new configuration, click New.