Dell POWEREDGE M1000E - Manual (Page 27)

Web Tools Administrator’s Guide xxvii
53-1002756-01
• Serial console and Telnet session logs
• syslog message logs
2. Switch Serial Number
The switch serial number and corresponding bar code are provided on the serial number label,
as illustrated below:
The serial number label is located as follows:
• Brocade 300, 5100, 5200, 5300, 6505, 6510, 6520, 7800, 8000, VA-40FC, and Brocade
Encryption Switch—On the switch ID pull-out tab located inside the chassis on the port side
on the left.
• Brocade 5000—On the switch ID pull-out tab located on the bottom of the port side of the
switch.
• Brocade DCX and 8510-8—On the bottom right on the port side of the chassis.
• Brocade DCX-4S and 8510-4—On the bottom right on the port side of the chassis, directly
above the cable management comb.
• Brocade 8000 —On the switch ID pull-out tab located inside the chassis on the port side
on the left.
3. World Wide Name (WWN)
Use the licenseIdShow command to display the WWN of the chassis.
If you cannot use the licenseIdShow command because the switch is inoperable, you can get
the WWN from the same place as the serial number, except for the Brocade DCX. For the
Brocade DCX, access the numbers on the WWN cards by removing the Brocade logo plate at
the top of the nonport side of the chassis.
Document feedback
Quality is our first concern at Brocade and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
[email protected]
Provide the title and version number of the document and as much detail as possible about your
comment, including the topic heading and page number and your suggestions for improvement.
*FT00X0054E9*
FT00X0054E9