Configuring netstat auto refresh, Configuring a syslog ip address, Removing a syslog ip address – Dell POWEREDGE M1000E User Manual
Page 60
32
Web Tools Administrator’s Guide
53-1002756-01
Configuring Netstat Auto Refresh
3
Configuring Netstat Auto Refresh
The Netstat Performance window displays the details about Ethernet management port statistics
like the Interface, MTU, Met, RX-OK, RX-ERR, RX-DRP, RX-OVR, TX-OK, TX-ERR, TX-DRP, TX-OVR, and
Flag.
To configure Auto Refresh, perform the following steps.
1. Open the Switch Administration window as described in
“Opening the Switch Administration
2. Select the Network tab.
3. Click Netstat Performance.
4. Select the Auto Refresh check box to automatically refresh the port details.
Clear the check box to disable auto refresh.
5. When enabled, enter the interval time in seconds in the Auto-Refresh Interval field.
The port details are automatically refreshed, based on the configured time interval. The
minimum value is 15 seconds.
Configuring a syslog IP address
The syslog IP represents the IP address of the server that is running the syslog process. The syslog
daemon reads and forwards system messages to the appropriate log files or users, depending on
the system configuration. When one or more IP addresses are configured, the switch forwards all
error log entries to the syslog on the specified servers. Up to six servers are supported. Refer to
Fabric OS Administrator’s Guide for more information on configuring the syslog daemon.
To configure a syslog IP address, perform the following steps.
1. Open the Switch Administration window as described in
“Opening the Switch Administration
2. Select the Network tab.
3. In the Syslog IP’s Configuration section, in the New IP field, enter an IP address in either IPv4
or IPv6 format.
4. Click Add.
The new IP address displays in the Syslog IP area.
5. Click Apply.
Removing a syslog IP address
To remove a syslog IP address, perform the following steps.
1. Open the Switch Administration window as described in
“Opening the Switch Administration
2. Select the Network tab.
3. Select a syslog IP in the table and click Remove.