Dell PowerEdge 650 - Manual (Page 35)

Closing the System
1. Ensure that you did not leave tools or parts inside the system.
2. Place the cover over the sides of the chassis, and slide the cover forward until it snaps into place. See Figure 5 -2 .
3. Tighten the thumbscrew at the back of the system to secure the cover.
4. To replace the bezel. See Figure 5 -1 .
a. Align the hole in the left-side bezel securing tab with the tab on the front panel.
b. While rotating the bezel toward the front panel, slide the bezel toward the key lock until the bezel snaps into place.
5. Reconnect the system to the electrical outlet, and turn on the system.
Checking the Equipment
This section provides troubleshooting procedures for components that connect directly to the I/O panel of the system. Before performing any of these
procedures, see "
External Connections ."
Troubleshooting the Video Subsystem
Problem
l Monitor
l Monitor interface cable
l Video memory
l Video logic
Action
1. Check the system and power connections to the monitor.
2. Determine whether the system has a remote access card and a video expansion card installed.
The system supports only the embedded video when using a remote access card.