Command options – Dell Brocade Adapters User Manual

Page 106

Advertising
background image

78

Brocade Adapters Installation and Reference Manual

53-1002144-01

Using the Brocade Adapter Software Installer

3

sh brocade_adapter_software_installer_solaris10_x86_<version>.bin

-DCHOSEN_INSTALL_SET=[DRIVER|GUI|BOTH|UTIL] -i silent

-

SPARC platforms
Install driver, HCM GUI, both, or management utilities. Overwrites the existing driver
installed on the system.

sh brocade_adapter_software_installer_solaris10_sparc_<version>.bin

-DCHOSEN_INSTALL_SET=[DRIVER|GUI|BOTH|UTIL] -i silent

Installs drivers and HCM GUI in silent mode (no interaction required).

sh brocade_adapter_software_installer_solaris10_sparc_<version>.exe -i

silent

Install drivers and the HCM GUI using a default installation properties file.

sh brocade_adapter_software_installer_solaris10_sparc_<version>.bin -f

HCMDefaultInstall.properties

Install software in silent mode using default installation properties file. Note that this is
recommended for silent mode.

sh brocade_adapter_software_installer_solaris10_sparc_<version>.bin -i

silent -f HCMDefaultInstall.properties

Command options

Following are the options that you can modify and in command strings. You can also edit these
fields in the properties file to change the default install set:

INSTALLER_UI=silent
Specifies that the installation mode should be silent.

CHOSEN_INSTALL_SET=BOTH
Specifies to install either the network and storage driver packages, the GUI (HCM), or all
components.:

-

BOTH - This parameter installs both the GUI and the driver. The HCM Agent starts
automatically after installation.

-

DRIVER - This parameter installs only the driver. The HCM Agent starts automatically after
installation.

-

GUI - This parameter installs only HCM.

-

UTIL - This parameter installs the management utilities.

CONT_NOARCH_DRIVER=[NO|YES]
Use for installing non-specific architecture drivers when kernel-specific driver is not available. If
set to YES, installs the noarch driver on Linux systems. No is the default value if you do not
specify the parameter as an argument.

Advertising