Dell Brocade Adapters User Manual
Page 37
Brocade Adapters Installation and Reference Manual
9
53-1002144-01
Converged network adapters
1
The Brocade 1007 mounts on a server blade that installs in an IBM BladeCenter® enclosure. The
adapter uses FCoE to converge standard data and storage networking data onto a shared Ethernet
link. Ethernet and Fibre Channel communications are routed through the DCB ports on the adapter
to the blade system enclosure midplane, and then onto switch modules installed in the enclosure.
For information on installing the Brocade 1007 CNA on a server blade, refer to
. For additional information related to the supported blade server, blade
system enclosure, and other devices installed in the enclosure such as I/O modules and switch
modules, refer to the installation instructions provided with these products.
1741
The Brocade
®
BR1741M-k 2P Mezz Card, also known as the Brocade 1741 mezzanine card, is
small-form factor (SFF) mezzanine card containing two ports operating at 10 Gbps that mounts on a Dell
blade server.
illustrates major components of the 1741 adapter. Please note that the following
illustration is representative and may have minor physical differences from the card that you purchased.
FIGURE 5
Brocade 1741 mezzanine card
1
ASIC with heat sink
2
Port WWN and MAC address label
3
OEM PPID and part number label
4
Brocade serial number label